Copyright © 2025, J. R. Goodenough

Contact

TpSelect Readme 3

Setting boundaries

As well as setting a range, you can additionally restrict the selection by setting from one to four boundaries along lines of latitude or longitude.

You can choose to exclude turning points which are north or south of a particular latitude or east or west of a particular longitude.

To set boundaries, click on the Boundaries... button.

Reviewing the selection

To review the selection made, click on the Review turnpoints... button. This will bring up another dialog containing two lists. On the right is the list of turning points selected and on the left the list of turning points remaining.

To add or remove turning points, select entries in the appropriate list box as described below.

To add turning points to the selection, choose the points you want to add in the left hand list. You can choose just one or as many as you want in one go. Then click on the right arrow button to move your chosen points from the Available list to the Selected list. Those points that you have added manually in this way will be shown in green.

To remove turning points from the selection, choose the points you want to remove in the right hand list. Then click on the left arrow button to move these points from the Selected list to the Available list. Those points that you have removed manually in this way will be shown in red.

Any points that would otherwise have been included, but have been excluded by boundary settings, are shown in blue in the Available list.